clapgeek logo
Which of the following options are part of the lifecycle phase of a WLAN project operation?
In the WLAN bandwidth design, the average bandwidth of the access users decreases linearly with the increase of the user.
WLAN surveyors can add Pins to locations where special information needs to be recorded during the WLAN Survery Pad survey.
Needle and Pin annotation support five functions: record, photo, text record, voice record and delete mark.
When the command "rate-limit client down 4096" is configured on the AC, what is the possible rate when the user downloads the Internet?
With the 7dBi antenna, the exit power of the two antennas (regardless of the feeder and interface losses) are?
In any country, the use of directional antennas can significantly increase the coverage area of the WLAN.
The following is the correct principle for the deployment of WLAN outdoor sites.
From the general business application of the high-density stadium, which of the following requires the lowest bandwidth?
Which of the following options are typical WLAN indoor-mounted coverage scenarios?
Huawei's S7700 series switches support PoE boards to supply power to PDs and PoE power redundancy. S7712 switches are supported.
What are the different ways of redundant PoE power supply?
In the scenario covered by 2.4G band, when the channel cannot be staggered by 1, 6, 11, it can be processed by 1, 5, 9, 13 (provided that
This country supports 1-13 channels)
In the WLAN Tester 2.0 tool, when a vendor group information is added to an AP packet in the global configuration, can one vendor correspond to several OUIs?
In the case of dense WLAN users and a large number of APs, when using the 2.4G band coverage, the HT40 mode can be used to increase the bandwidth.
A wireless AP and wireless terminal support MIMO 2*2. When the AP works in HT20 mode, which of the following data is closest to the wireless terminal?
Throughput (the terminal is in the key coverage area)?
In the WLAN enterprise campus network, which of the following is unachievable with regard to SSID planning?
What is the correct description of using dynamic load balancing in high-density scenarios?
During the establishment of the dual-link backup active/standby CAPWAP tunnel, which of the following parameters should be included in the Discover Response sent by the active and standby ACs?
Regarding the installation and deployment of the room AP, what is wrong with the following statement?
Which of the following is the highest security strength of the encryption algorithm?
The following is true about deploying the AP6310SN in the warehouse coverage (the AP is placed at one end of the warehouse, and the antenna feeders are not equal in length).
In the WLAN outdoor coverage scenario, in order to ensure uplink and downlink balance, what is the most effective way?
A WLAN engineer uses the WLAN Tester 2.0 tool for surveying. In order to quickly understand the coverage of the live signal, the following operations are correct.
What is the correct statement about the function of the WLAN Survey PAD survey tool?
In the WLAN Tester 2.0 heat map, the tip box displays the following information. According to the information in the figure, the following statement is correct?
Signal field strength calculation formula: (do not consider interference, line loss and other factors)?
The following options are incorrect about the WLAN forwarding mode description?
In an outdoor WLAN deployment scenario, the channel design must consider the interference of the radar channel.
In the WLAN project network design of the warehousing and logistics industry, what are the correct descriptions of the channel planning considerations?
TESTED 21 Nov 2024